I like the version 3.0 TIE Pilot, but I still think that the first version is the best.
I had to use a lot more creativity on the 1st one. The Only Orig. TIE Parts were the Helmet. I've never really liked the Sculpt of the Saga TIE Pilot's Helmet that I used on that one. So I prefer the POF2 TIE Helmet for these Customs although it still has it's Short commings. I hope GG will give us a nice Bust-Up's Version to work w/.
I think you should add some black fabric to make some of his bodysuit (especially on the torso area).
Are you able to fit the arm armor over the skeleton's arms without cutting the armor?
I did add a little Black Fabic to this one, but it's hard to see accept for the Back Shot. I'm always afraid I'll hide too much of the Skelleton w/ the Fabric on the Armored Deadites. Mabey I'll give the Next one a little more of the Body Glove.
The Armor Fits like a Glove. The Great thing about the Bust-Up's Torso is that it is wide enough to fit the Deaite's Rib- Cage. It is also one Solid Piece of Molded Plastic, So ther are no Seems to Split on You when You force the Rib Cage Into the Chest Plate.
The Arms and Legs of the Deadites come Apart very easily. So after You liberate the and Hollow Out the Armored Pieces from your Clone Fodder, Slide the Forarm, Elbow, And Bicep-Shoulder( I like to Keep the Shoulder and Bicep Armor intact so I don't have to Glue the shoulder pads on Seperately)Armor over the Top of the Deadite's Arm. I always keep a Hot Bowl of Water nearby to Soften some of the tighter Armor pieces. So the Strech over the Deadite's Shoulder and elbow.
The Legs are Much Easier . Just Cut the Feet off and Slide the Thigh armor in Place. The Thighs fit a little loose so I use a little Sculpting Putty to wedge it Tighter around the Deadites Legs. The Knee and boot Armor I leave Intact and Slide them over the Deatite's Legs like a boot.
I hope that Helps