Hi everyone, just got a couple VTSC Scouts and I decided to make a custom outta one.
Still no camera so no pics yet, I am saving up slowly so just be paitient.
Anyways, I cut the ball joint off of the Scout (SACRILIGE!!!) and trimmed the neck post from an extra Saga Veers to fit it. Then I glued it on.
For the head any BBI figure should do, but the Elite Force Grenadier looks the best. I dremeled out the head to fit on the ball. So far it looks cool. The hardest part was dremeling the head though.
For the helmet I plan to hollow it out enough so it fits. Then I will make cuts along the seams of the helmet where the face plate flips up. I might only do the goggle area and leave the bottom untouched so the helmet can stay on better. I plan to do it very slowly. So I cut out the front. and make a hinge at the top and a locking mechanism for the bottom.
Now this is where I am stuck. I need some suggestions on how to make the hinge and a tiny but strong snap lock at the bottom.
I am open to any suggestions for this project, so LMK what you think.