Thanks Guys for all the Great feedback.
This one was a lot more complicated then it looked.
The Helmet is Spliced from the Bust Up's AT-AT Driver's helmet and the AT-TE Gunner's Helmet.
The head of the Bust up AT-AT Driver is made from 2 seperate Pieces. It was a a royal pain the You Know Where, to get the pieces apart.
Once I got the the Helmet Seperated, I had to Dremel alot to get it to fit Properly on the Gunners Head and leave enough room to get the Face Plate in there.
The Face Plate is a Biseced Clone Helmet. I also had to trim the Forhead off to get it to fit .
I was hoping to make the Helmet removable, but the fit is so tight, that the head pops off when I try to remove it.
I also Modified the Clone Rifle, although it's a little hard to tell from the pic. I added the Clip from J'QUILLE's blaster Rifle to the side of the Clone Rifle. I figured this guy, being the Door Gunner of a Gunship, would need the extra Ammo.
Thanks Again,
Fritzkrieg